Author Topic: Conductivity of fastrack (Read 3900 times)

john2017 · « **on:** July 27, 2017, 10:24:05 am »

I seem to have problems with conductivity in fastrack. From one time of running the train to the next your not sure if it's going to run. If you slightly twist the track power goes off and on. I was told to try soldering leads to the track but solder to fastrack rails doesn't seem to stick. Any advise on conductivity fixes and or soldering ?

Sent from my iPhone using Tapatalk

djacobsen · « **Reply #1 on:** July 27, 2017, 09:47:31 pm »

John 2017

Hello & Welcome to the Forum

Only recomendation I can make is
Clean the track and make sure the pins are clean and tight.

When you are trying to solder are you using flux?
If not, that is possibly why it is not sticking.
Also you should rough up the spot where you are trying to solder with a piece of sand paper,
it will create a better surface for the solder to cling to.

Hope this helps.

Happy Rails!
Dave

john2017 · « **Reply #2 on:** July 28, 2017, 06:36:48 pm »

Quote from: djacobsen on July 27, 2017, 09:47:31 pm

John 2017

Hello & Welcome to the Forum

Only recomendation I can make is
Clean the track and make sure the pins are clean and tight.

When you are trying to solder are you using flux?
If not, that is possibly why it is not sticking.
Also you should rough up the spot where you are trying to solder with a piece of sand paper,
it will create a better surface for the solder to cling to.

Hope this helps.

Happy Rails!
Dave

Thanks for the advice Dave. I will definitely give it a try

Sent from my iPhone using Tapatalk

Lionel Train Forum

News:

Author Topic: Conductivity of fastrack (Read 3900 times)

john2017

Conductivity of fastrack

djacobsen

Re: Conductivity of fastrack

john2017

Re: Conductivity of fastrack

Member Photos

Recent Threads

Menu