Lionel 022 turnout buzzing on layout

• Lionel 022 turnout buzzing on layout
  Posted by bgd64 on 22 Dec, 2018 19:17
• I have 2 remote 022 turnouts. one left, one right (bought recently on ebay as refurbished) on my layout as a siding track. when I try to switch the the right hand turnout  to route the train to the siding track it starts buzzing (shorts) and wont change over. the left hand turnout works fine. The isolation pins are in the factory positions. any help would be appreciated!
• 
  
• #1 Reply
  Posted by TrainLarry on 23 Dec, 2018 09:36
• Make sure the controller is wired correctly to the turnout.
  
  Test the turnout by disconnecting it from the track, and disconnecting the controller. Apply power to the center and a running rail of the turnout. Take a screwdriver and short the center terminal of the turnout to the left terminal, and then short the center terminal to the right terminal. The turnout should throw in both directions. If it does not, there is an internal problem with the turnout.
  
  See here for a wiring view, http://pictures.olsenstoy.com/cd/swt/stc022a.pdf
  and here for a phantom view of the turnouts.
  http://pictures.olsenstoy.com/cd/swt/stc022c.pdf
  
  This should help you trace the wiring for proper hookup and operation.
  
  
  Larry
•