Show Posts - njjrjohn

Hi, Also, I have a Breakman's Riviter set with a Knuckle Coupler Riviting Tip, a Shoe/Armature Spring Tip and a BR-1 Marking Tip.  Would any of that be usable for penning in a new rivet?

Thanks Larry!  Th3e stock number for the car is 36621; milk car.

Is it possible to reattach a coupler to the baseplate?  What type of pin would be used to do this?

This is to update my question.  After studying how these signals work a little more, I don't think there is any built in mechanism that makes the lamps alternate.  I am guessing the alternate flashing is created by the controller that is used to wire them to the track.  Does that sound right?  Does anyone know anything about this?

HI Everyone,  I got an answer to my question so thought I'd post it.  On this soundboard, Port J1 is for power and J2 is for the speaker.

The two lamps on this signal are wired to flash simultaneously, i.e., both flash on and off at the same time.  What would I need to rewire them so that each bulb flashes alternately?  It's probably a different board, or chip to replace the one that's originally built into the unit, but I don't know what part it would be.  Thank you.

This board has 2 ports, one for a speaker and one for power.  Anyone know which is which?  They're numbered J1 and J2.