Lionel Trains - Lionel Train Forum - Model Train Forum

Lionel Trains Workshop => Lionel Maintenance & Repair => Topic started by: mtfrizzell on June 16, 2017, 10:14:45 pm

Title: Re: How do I remove the truck held in place by a rivet?
Post by: djacobsen on June 17, 2017, 08:35:05 am

Normally, you would drill out the rivet, then replace it with a slightly longer one if you were going to place a washer between the truck and frame.
You can tighten up the rivet by tapping very lightly or if you have a press, using that. 
Be careful not to make the rivet too tight, it will bind the trucks' movement.
(learned the hard way)
If rivets are not available, I have used small nuts and bolts to attach trucks to frames, using a dab of loctite on the nut.

Happy Rails.
 Dave

Title: How do I remove the truck held in place by a rivet?
Post by: mtfrizzell on June 16, 2017, 10:14:45 pm

How do I remove/replace the rivet so as to tighten up the floppiness of the truck of my Minards flatcar?   I'd like to replace the washer with a thicker one.  Or can I just wail on the rivet with a hammer and a nail punch to make the connection tighter like Tim the Toolman Taylor with a hammer drill.
Thanks,
Mike


Sent from my iPad using Tapatalk