Author Topic: Locomotive Runs without remote (Read 1373 times)

hoser007 · « **on:** December 08, 2020, 01:45:56 pm »

I'm brand new to Lionel O gauge so please excuse the terminology if I'm using it wrong. I bought an off the shelf LionChief set, some extra track and a few switches and set up in the basement. Everything ran fine for two weeks. Today, I plugged in the power and the locomotive began running at high speed without the remote on. The locomotive wouldn't move though, the traction wheels just spun in place. I unplugged, waited a few minutes and tried again. Same thing. I don't see anything visible that would cause this, track is clean, power is clean, no shorts etc. Help!!!

RixTrax · « **Reply #1 on:** December 10, 2020, 11:55:17 pm »

Quote from: hoser007 on December 08, 2020, 01:45:56 pm

I'm brand new to Lionel O gauge so please excuse the terminology if I'm using it wrong. I bought an off the shelf LionChief set, some extra track and a few switches and set up in the basement. Everything ran fine for two weeks. Today, I plugged in the power and the locomotive began running at high speed without the remote on. The locomotive wouldn't move though, the traction wheels just spun in place. I unplugged, waited a few minutes and tried again. Same thing. I don't see anything visible that would cause this, track is clean, power is clean, no shorts etc. Help!!!

I think the control board in the locomotive has failed.

Sent from my iPad using Tapatalk

hoser007 · « **Reply #2 on:** December 11, 2020, 08:29:28 am »

Thanks. After a tear down, the front motor is not running, but does not appear to be toasted. Is this common in the off the shelf LionChief product? Seems so.

RixTrax · « **Reply #3 on:** December 11, 2020, 10:13:36 am »

Quote from: hoser007 on December 11, 2020, 08:29:28 am

Thanks. After a tear down, the front motor is not running, but does not appear to be toasted. Is this common in the off the shelf LionChief product? Seems so.

If you have the skill and a voltmeter check to see if that motor is getting any power. It is less likely that a can motor failure is the issue than a bad circuit board. If it’s new it should be covered under warranty. That doesn’t help you immediately however.

Sent from my iPad using Tapatalk

hoser007 · « **Reply #4 on:** December 11, 2020, 02:08:46 pm »

Thanks. I did check and front motor has no power. I’m going to send back to Lionel and hope they make it right. Set was only two weeks old. Seems like I’m not the first to have the issue with LionChief sets and particularly this one.

Lionel Train Forum

News:

Author Topic: Locomotive Runs without remote (Read 1373 times)

hoser007

Locomotive Runs without remote

RixTrax

Re: Locomotive Runs without remote

hoser007

Re: Locomotive Runs without remote

RixTrax

Re: Locomotive Runs without remote

hoser007

Re: Locomotive Runs without remote

Related Topics

Member Photos

Recent Threads

Menu